Geothermal Earth Loops for Topeka

In part three of our Introduction to Geothermal series, we are going to talk about geothermal loop systems and how each type works.

A geothermal loop is the series of underground pipes used to transfer heat to and from the earth. These pipes are made out of high-density polyethylene to create a durable, long-lasting system. They are joined together using thermal fusion which will produce a bond that is much stronger than the original pipe itself. In fact, a properly installed loop can last up to 200 years.
 
There are two main types of geothermal loop systems that are mostly used in today's installs: open loop systems and closed loop systems. Each system have unique pros and cons for your heating or cooling solution. We at Ground Source, Inc. have the training and experience on both types, and we will help you by selecting the best choice for your geothermal installation.

Open loop geothermal solutions are designed to utilize the natural groundwater from underneath your home. Using a well, water is drawn from an existing aquifer and delivered to the geothermal heat pump where its heat is taken out and the water is pumped back into the ground or to a designated runoff. Since the water that you are using is not being altered in any way, the only thing that is being returned to the earth is water that is just a little warmer or cooler (depending whether you're in heating or cooling mode).

One thing to keep in mind with an open loop system is water quality. Mineral build-up can take place from poor quality water. This can be kept under control with an occasional cleaning. If the water in the ground has higher iron content, you may want to make sure that the discharge water is prevented from coming in contact with air before it is returned in order to prevent clogs.
 
Closed loops are just as they sound. Instead of pumping water from a well and depositing it elsewhere, water is circulated in a fully sealed circuit with a small amount of environmentally-friendly antifreeze.
 
There are two main types of closed loop installations: horizontal and vertical. Installing the system horizontally requires a decent amount of property. The piping is buried in trenches between 4 and 6 feet deep and can be up to 400 feet long. If you live on a smaller lot, the loops can be installed vertically by boring straight down using drilling equipment. This type of installation can be installed in as little as a 10ft by 10ft  area.
 
In either case, the bigger the building, the bigger the geothermal heat pump and loop needs to be. A good ball park figure is that for every ton of system capacity, you will need 500 to 600 feet of pipe.
 
Contact Ground Source, Inc. today to learn more about what system options are available to you here in Topeka.